Clevis Tongue

In Stock

Clevis tongue fittings in galvanised cast iron with M16 bolt size. Choose PLPTC-070-1 with a 70 kN catalogue load figure or PLPTC-120-1 with a 120 kN catalogue load figure.

Both options have an 18 mm tongue hole. Check the required rating and mating connection dimensions against the assembly drawing. For help, call (08) 9258 8444.

P/N: PLPTC Category:

Description

This clevis tongue range provides a tongue connection at one end and a clevis connection at the other. PLP lists the TC series as galvanised cast iron fittings. Choose TC-070-1 or TC-120-1 to match the required catalogue load figure.

Both options use an M16 bolt size. However, the part codes identify different load ratings, so quote the full stock SKU when ordering. Also check the mating hardware and the connection layout against your assembly drawing.

Clevis tongue model comparison

SpecificationTC-070-1TC-120-1
Stock SKUPLPTC-070-1PLPTC-120-1
Catalogue load figure70 kN120 kN
Bolt sizeM16M16
Material and finishGalvanised cast ironGalvanised cast iron
Tongue hole diameter H18 mm18 mm
Drawing dimension S72 mm72 mm

Engineering Supplies lists the load figures under minimum failing load. PLP labels them as tension ratings. Neither figure is presented here as a working load limit; use the approved assembly design to establish the required duty.

Dimensions and fitting selection

The Engineering Supplies catalogue gives the same connection dimensions for both models: A = 16 mm, B = 20 mm, D = 22 mm and E = 28 mm. Refer to its drawing for the measurement locations. The 18 mm tongue hole and 16 mm bolt diameter are separate dimensions.

First, confirm whether the assembly calls for the 70 kN or 120 kN option. Then check the clevis opening, tongue thickness and bolt arrangement against the adjoining parts. A matching bolt size alone does not confirm the complete connection.

  • Galvanised cast iron TC series fittings.
  • M16 bolt size on both listed models.
  • Choice of 70 kN or 120 kN catalogue load figure.
  • Full stock codes identify the required variation.

Catalogue and ordering help

See page 145 of the Engineering Supplies catalogue for dimensions. For the TC series material and rating table, refer to page 7-8 of the PLP hardware and fittings catalogue.

Select the required variation to order or request a quote. Alternatively, send us the stock SKU, quantity and assembly drawing for help checking the fitting. Call Engineering Supplies on (08) 9258 8444 or email sales@engsup.com.au.

Additional information

Minimum Falling Load kN

70, 120